Question No 1

A customer mentions that their intercluster SnapMirror replication operations consistently take much longer than normal. While troubleshooting, you want to initiate a test SnapMirror session to collect performance data. How would you accomplish this task?

Choose the Choices:

Run the network test - path command to simulate a SnapMirror connection and record the latency/throughput data.

View the active network connections to the node to see if there a large number of active connections.

Use the ifstat command to collect network performance data for the physical interface.

Run the network statistics lif show command for the intercluster LIF to simulate a network connection.

Question No 2

The root aggregate on your single - node ONTAP cluster failed. You have the configuration backups saved on your FTP server? In this scenario, which two steps are part of the recovery procedure? (Choose two.)

Choose the Choices:

Perform a Netboot using the configuration backup.

Create a new aggregate and set its ha_policy option to sfo.

Boot into maintenance mode.

Create a new root aggregate and set its ha_policy option to cfo.

Question No 3

When does ONTAP 9.5 overwrite a block that contains existing data?

Choose the Choices:

Question No 4

Your customer has initiated several volume move commands to redistribute the workload in their 8 - node cluster. To verify that this process is not affecting their client access, they were monitoring the network switches that provide client access, but they do not see the network load of the volume move command. In this scenario, what is the reason for the behavior?

Choose the Choices:

The volume move command uses the HA iWarp interconnect, not the client access switches.

The volume move command uses copy offload protocol, so it does not show up when monitored.

The volume move command uses the intercluster LIFs, not the data LIFs.

The volume move command uses the cluster interconnect switches, not the client access switches.

Question No 5

A customer reports that a takeover has been disabled on an HA pair. What would be a cause for this to happen?

Choose the Choices:

The HA interconnect is not functioning properly.

There is a disk running too hot.

The interface for the hardware assist has become unavailable.

The cluster network is not functioning properly.

Practice NetApp NS0-592 Exam Questions

Question No 1

Question No 2

Question No 3

Question No 4

Question No 5

NS0-592 Exam Features

NS0-592 PDF Dumps