What does the term composable mean when applied to HPE infrastructure?

When configuring a single ProLiant Gen10 server, which embedded tool can be used to deploy a reliable and consistent configuration?

Read the question, and then refer to the exhibit. <Switch - A>display int Ten - GigabitEthernet 1/0/1 Ten - GigabitEthernet1/0/1 Current state: UP Line protocol state: UP IP packet frame type: Ethernet II, hardware address: d894 - 03fb - 793d Description: Ten - GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK SFP_PLUS 10Gbps - speed mode, full - duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow - control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max - ratio: 100% Multicast max - ratio: 100% Unicast max - ratio: 100% PVID: 1 MDI type: Automdix Port link - type: Trunk VLAN Passing: 10 VLAN permitted: 10 Trunk port encapsulation: IEEE 802.1q Port priority: 0 <SNIP> An administrator connected a hypervisor to interface Ten - Gigabit Ethernet1/0/1 in a switch. The administrator created virtual machines in VLAN 10 and 20 on the hypervisor. These VLANs are configured to be tagged on the hypervisor. The administrator found that all the virtual machines within VLAN 20 can communicate with each other, but not to any resource on VLAN 20 outside the hypervisor. What must you do to resolve this issue?

You are reviewing a series of MSA2052 storage designs for a customer’s remote locations. Their largest remote site requires the highest possible level of internal data protection with at least 20 TB of storage. Which disk drive design is adequate for this site?

What is the correct cable type to use when connecting a server to a switch using 10 Gbps Short Range (SR) SFP+ optical connections?