If a VRRP Master router is rebooted, what is the default behavior once it comes back online?
Question No 2
If a group of routers are running VRRP with a virtual router ID of 155, which MAC address will be
used to respond to the ARP requests for the virtual IP?
Question No 3
An administrator just finished configuring a Dell EMC N - Series switch. After rebooting the switch, the
administrator notices that all the configuration settings just entered are gone.
Which command did the administrator fail to enter?
Question No 4
When configuring a PBR route - map, what are the configurable "SET" options?
Question No 5
Switch - 1(config)# interface tengigabitethernet 1/0/1
Switch - 1(config)# switchport mode access
Switch - 1(config)# switchport trunk allowed vlan 10, 20
Switch - 1(config)#
Switch - 1(config)# interface tengigabitethernet 1/0/3
Switch - 1(config)# switchport mode access
Switch - 1(config)# switchport access vlan 10
Switch - 2(config)# interface tengigabitethernet 1/0/2
Switch - 2(config)# switchport mode trunk
Switch - 2(config)# switchport trunk allowed vlan 10, 20
Switch - 2(config)#
Switch - 2(config)# interface tengigabitethernet 1/0/6
Switch - 2(config)# switchport mode access
Switch - 2(config)# switchport access vlan 20
A network administrator is troubleshooting why Host 1 cannot communicate with Host 2.
Based on the switch output shown in the exhibit, what is the reason for the communication issue?